Atlantic Society of Radio Controlled Modellers | |
https://www.asrcm.ns.ca/cgi-bin/yabb2/YaBB.pl
Atlantic Society of Radio Control Modellers >> General Discussions >> beading roller for aluminum skis https://www.asrcm.ns.ca/cgi-bin/yabb2/YaBB.pl?num=1330441031 Message started by speedbird on Feb 28th, 2012 at 10:57am |
Title: beading roller for aluminum skis Post by speedbird on Feb 28th, 2012 at 10:57am
does anyone have access to a beading roller and a brake?
trying to make 15inch aluminum skis |
Title: Re: beading roller for aluminum skis Post by Bill G on Feb 28th, 2012 at 11:20am
All the places that I used here in Truro are going or gone now Brian.
If you have the blanks cut out, any sheet metal or hot air ducting firm should be able to bead them for you at little cost. |
Title: Re: beading roller for aluminum skis Post by argus on Mar 3rd, 2012 at 12:19pm
Check with Russ Vining, of Russ Vining Mechanincal. Last time I was in his shop was on Young St, between Windsor St and the Superstore. (Ex prez of HRCC).
Wade |
Title: Re: beading roller for aluminum skis Post by speedbird on Mar 3rd, 2012 at 11:01pm
thanks to all
I discovered mariner forge Chris the owner is into RC Also Brian Smyth has a pair |
Atlantic Society of Radio Controlled Modellers » Powered by YaBB 2.5.2! YaBB Forum Software © 2000-2024. All Rights Reserved. |